For This Installment We Installed Air Lift's New Auto Pilot System.
This unit gives you accurate, instant control over your ride system with features like; one touch ride height, auto ride height on start, individual wheel control, inflate and deflate all buttons (aka pancake), built in digital volt meter, auto leak detection, special tuning, and only one wire to the dash. The one touch ride height allows you to return to your programmed ride height on demand so you can set your aligned ride-height and prevent tire wear. The auto ride height on start will lift your vehicle to the programmed ride height with the start of the engine and can be disabled if desired. The individual wheel control allows you to adjust each wheel separately, while the all inflate and deflate buttons give you the "pancake" option with one switch. Accurate manifold mounted transducers are the most accurate pressure sensors that come pre-mounted to the valves which eliminate the risk of leaks, and makes for an easier install. The auto leak detection monitors all four corners so if a leak occurs, the system will automatically add air accordingly and warn you of a problem. The tuning feature teaches the system the exact requirements to lift each wheel and ensures that the auto ride height function is perfect every time. Also with only one wire to run to the dash running airlines, power lines, and wiring every switch independently is a thing of the past. One wire now does it all. Follow along and see just how easy this kit was to install and enjoy! For more information check out the companies listed in the Source Box.
 1.The kit comes complete with...  1.The kit comes complete with a digital control panel, digital control ECU, Pezio pressure transducers, plug 'n play solenoid harnesses, an Ethernet cable, 1/2-inch PTC to transducer fittings, and an inline fuse holder. |  2.Everything was prewired...  2.Everything was prewired and assembled in a waterproof casing to clean up the install and keep it safe from the elements. |  3.The closer you mount the...  3.The closer you mount the unit to the valves and air management, the cleaner the install will turn out. so a mount was built to house the unit right behind the valves. |
 4.Each corner was measured...  4.Each corner was measured so that the excess could be cleaned up with zip ties and rolled into the box. |  5.The sensors are labeled...  5.The sensors are labeled for easy installation, and each corner was ran and installed in the corresponding airline. |  6.The 12v accessory wire was...  6.The 12v accessory wire was taped under the column harness for accessory power. |
 7.With all the loose ends...  7.With all the loose ends tied up the unit box was completely sealed from the elements. |  8.The Ethernet cable is ran...  8.The Ethernet cable is ran cleanly to the front and the Digital Controller rests safely but temporarily in the center console of the Dime. Once the interior is planned out the controller will find a more permanent home. |  9.Here's a nice look at the...  9.Here's a nice look at the Controller on with the vehicle laid out. And just like that the world is at your hands so go out and show off your new unit. |
 | | |