Snap-On VersaDriver Impact Wrench - Versatile

In our pastime, we all need access to quality tools to be able to do as much as we possibly can to our own rides. The reason? When all is said and done, it leaves more money in your pocket to do things like pay the rent and the note on your truck! That's why when we saw the newest impact wrench from Snap-On, we decided it was the ultimate impact wrench for mini-truckers. Why? Well, the answer is dead simple. If you could buy one impact wrench that could do the job of as many as seven different impacts, you would do it. That's what the IM3100 VersaDriver from Snap-On is capable of - simply pull a retaining clip and swap out the driver head. For more information, contact Snap-On using the information listed in the source box.

1.First, take a look at a...        read full caption 1.First, take a look at a few key parts of the VersaDriver. From the front, the drive end looks different from other impacts, and in a minute, you'll know why.	2.Next, we'll look at the...        read full caption 2.Next, we'll look at the VersaDriver's bypass system. This allows the VersaDriver to deliver 275 lb-ft of torque in reverse mode and 200 lb-ft in the impact's quiet mode with the bypass closed.	3.At the rear of the VersaDriver,...        read full caption 3.At the rear of the VersaDriver, you'll find the lever for forward/reverse, as well as the impact's regulator knob.
4.To change out a driver head,...        read full caption 4.To change out a driver head, simply lay the impact on its side and locate the retaining clip.	5.Using a flathead screwdriver,...        read full caption 5.Using a flathead screwdriver, pry the clip out of place (don't bend it) and set it to the side.	6.Remove the driver head you...        read full caption 6.Remove the driver head you don't want to use, along with the driver retainer. Make note of the position of the driver retainer for reinstallation.
7.Place the driver retainer...        read full caption 7.Place the driver retainer over the end of the new driver you want to use with the flat part of the collar on the driver retainer toward the body of the VersaDriver.	8.Push the driver head into...        read full caption 8.Push the driver head into the VersaDriver and set the retaining clip into place. Make sure the driver retainer is rotated to allow the retaining clip to pass by each side of the driver retainer.	9.Now that you can do all...        read full caption 9.Now that you can do all this with just one impact wrench, why would you want to own anything else?